|本期目录/Table of Contents|

[1]吕剑渊,许文倩,张玉良,等.蜗壳隔舌安放角对离心泵特性及流动稳定性的影响[J].浙江理工大学学报,2021,45-46(自科三):351-364.
 L Jianyuan,XU Wenqian,ZHANG Yuliang,et al.The influence of volute tongue angle on the characteristic and flow stability of centrifugal pump[J].Journal of Zhejiang Sci-Tech University,2021,45-46(自科三):351-364.
点击复制

蜗壳隔舌安放角对离心泵特性及流动稳定性的影响()
分享到:

浙江理工大学学报[ISSN:1673-3851/CN:33-1338/TS]

卷:
第45-46卷
期数:
2021年自科第三期
页码:
351-364
栏目:
出版日期:
2021-04-28

文章信息/Info

Title:
The influence of volute tongue angle on the characteristic and flow stability of centrifugal pump
文章编号:
1673-3851 (2021) 05-0351-14
作者:
吕剑渊许文倩张玉良李龙海窦华书
1.浙江理工大学机械与自动控制学院,杭州 310018;2.衢州学院浙江省气动设备技术重点实验室,浙江衢州 324000
Author(s):
L Jianyuan1 XU Wenqian1 ZHANG Yuliang2 LI Longhai1 DOU Huashu1
1.Faculty of Mechanical Engineering & Automation, Zhejiang Sci-Tech University, Hangzhou 310018, China; 2.Key Laboratory of AirDriven Equipment Technology of Zhejiang  Province, Quzhou University, Quzhou 324000, China
关键词:
离心泵蜗壳隔舌安放角能量耗散压力脉动熵产率
分类号:
TH311
文献标志码:
A
摘要:
采用数值模拟方法对蜗壳隔舌安放角角度的大小进行研究,分析其对离心泵内部流动状态的影响。根据比转速与蜗壳隔舌安放角的关系,设计4种蜗壳隔舌安放角方案;采用NavierStokes方程与SST(剪切应力传输)kω湍流模型来研究高比转速离心泵的瞬态内部流动。结果表明:在外特性方面,蜗壳隔舌安放角为35°时,离心泵的扬程和效率最高,并且大流量工况时,蜗壳隔舌安放角为29°和32°的离心泵扬程和效率都急剧下降;在能量方面,蜗壳隔舌安放角从29°增大到38°的过程中,离心泵的能量损耗和熵产率都先减小后增大,在蜗壳隔舌安放角为35°时取得最小值;在内部流动稳定性方面,适当地增大蜗壳隔舌安放角,可以明显地降低蜗壳内部的压力脉动,减少蜗壳隔舌处的回流,使蜗壳和叶轮的内部流动更加稳定。因此,适当地增大蜗壳隔舌安放角对离心泵内部流动的稳定起促进作用,同时也能够抑制能量的耗散。

参考文献/References:

[1] Wu Y L. Instability of system caused by hydraulic machinery[M]// Wu Y L, Li S C, Liu S H, et al. Vibration of Hydraulic Machinery. Dordrecht: Springer Netherlands, 2013: 377-429.
[2] Li W, Li E D, Ji L L, et al. Mechanism and propagation characteristics of rotating stall in a mixedflow pump[J]. Renewable Energy, 2020, 153: 74-92.
[3] Prunières R, Inoue Y, Nagahara T. Investigation of the flow field and performances of a centrifugal pump at part load[J]. IOP Conference Series: Earth and Environmental Science, 2016, 49: 032015.
[4] Guo R, Li R N, Zhang R H, et al. Numerical study of the unsteady flow characteristics of a jet centrifugal pump under multiple conditions[J]. Processes, 2019, 7(11): 786.
[5] Ren X M, Fan H G, Xie Z F, et al. Stationary stall phenomenon and pressure fluctuation in a centrifugal pump at partial load condition[J]. Heat and Mass Transfer, 2019, 55(8): 2277-2288.
[6] Zhou P J, Dai J C, Li Y F, et al. Unsteady flow structures in centrifugal pump under two types of stall conditions[J]. Journal of Hydrodynamics, 2018, 30(6): 1038-1044.
[7] Tao R, Wang Z W. Comparative modeling and analysis of the flow asymmetricity in a centrifugal pump impeller at partial load[J]. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2020, 234(2): 237-247.
[8] Yang Y F, Li W, Shi W D, et al. Numerical investigation on the unstable flow at offdesign condition in a mixedflow pump[J]. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2019, 233(7): 849-865.
[9] Ye W X, Qian Z D, Huang R F, et al. Instability analysis for a centrifugal pump with straight inlet pipe using partially averaged NavierStokes model[J]. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2020:
095765092091954.
[10] Lai F, Zhu X Y, Li G J. Numerical investigation of energy loss in a centrifugal pump through kinetic energy dissipation theory[J]. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2020, 234(19): 3745-3761.

相似文献/References:

[1]黄远民,李昳,崔巧玲,等.IS型离心泵内部流动的三维数值模拟[J].浙江理工大学学报,2011,28(02):221.
[2]郑路路,窦华书,蒋威,等.基于能量梯度方法的叶片数对离心泵稳定性影响研究[J].浙江理工大学学报,2016,35-36(自科1):71.
 XU Jun,JIANG Kejian,WANG Jun.Adaptive Active Control of Single Freedom Simple  Harmonic Vibration of Electromagnet Bearing[J].Journal of Zhejiang Sci-Tech University,2016,35-36(自科三):71.
[3]张鑫,崔宝玲,周汉涛,等.不同起始直径分流叶片的离心泵内部流场数值分析[J].浙江理工大学学报,2016,35-36(自科2):225.
 ZHANG Xin,CUI Baoling,ZHOU Hantao,et al.Numerical Analysis on Internal Flow Field of Centrifugal Pump  with Splitter Blades of Different Initial Diameters[J].Journal of Zhejiang Sci-Tech University,2016,35-36(自科三):225.
[4]林培锋,徐文斌.进口肋条对离心泵定常流动影响的数值研究[J].浙江理工大学学报,2019,41-42(自科四):461.
 LIN Peifeng,XU Wenbin.Numerical study of influence of inlet ribs on steady flow of centrifugal pump[J].Journal of Zhejiang Sci-Tech University,2019,41-42(自科三):461.
[5]王春贺,林培锋.三角形仿生微槽对离心泵定常流动影响的数值研究[J].浙江理工大学学报,2023,49-50(自科二):246.
 WANG Chunhe,LIN Peifeng.Numerical study of influence of triangular bionic  microgrooves on the steady flow of centrifugal pumps[J].Journal of Zhejiang Sci-Tech University,2023,49-50(自科三):246.

备注/Memo

备注/Memo:
收稿日期:2020-12-18
网络出版日期:2021-02-04
基金项目:国家自然科学基金项目(51536008, 51579224);浙江省重点研发计划(2018C03046)
作者简介:吕剑渊(1993-),男,江西上饶人,硕士研究生,主要从事流体机械理论及应用方面的研究
通信作者:许文倩,E-mail:xuwenqian@zstu.edu.cn
更新日期/Last Update: 2021-06-29